RAM 2500 Van V8-318 5.2L VIN T Magnum CNG SFI (1997)
Power Door Lock Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Power Lock Switch Remove/Install
2. Remove the power switch bezel from the door trim panel by inserting a standard blade screwdriver into the notch on the forward end of the bezel.
Push the screw driver in to depress the locking tab. Pull the switch bezel out and forward to remove it from the door trim panel.
3. Gently pry the locking tabs of the switch wire harness connectors away from the switch and carefully unplug the switch.
4. Reverse the removal procedures to install.
