RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
1. Position the panel/floor door actuator (1) to the back of the HVAC housing (4). If necessary, rotate the actuator slightly to align the splines on the
actuator output shaft (3) with those on the panel/floor door actuator coupler (2).
2. Install the two screws (4) that secure the panel/floor door actuator (3) to the HVAC housing (1). Tighten the screws to 1.1 Nm (10 in. lbs.).
3. Connect the HVAC wire harness connector (2) to the panel/floor door actuator.
4. When equipped with center floor console, install the radio See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Radio/Stereo/Service and Repair/Removal and Replacement/Radio - Installation.
5. When not equipped with center floor console, install the cup holder See: Body and Frame/Interior Moulding / Trim/Drink Holders/Service and
Repair/Instrument Panel Cupholder - Installation.
6. Install the instrument panel center bezel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Bezel - Installation.
7. Reconnect the negative battery cable.
8. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
DEFROST DOOR ACTUATOR
