RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
1. Remove the front seats See: Body and Frame/Seats/Service and Repair.
2. Roll back the front carpet from under the instrument panel toward the rear of the vehicle See: Body and Frame/Interior Moulding /
Trim/Carpet/Service and Repair/Carpet - Removal.
3. Disengage the rear floor ducts (2 and 5) from the floor support bracket (3) and from the studs (4) located on the floor panel.
4. Disconnect the rear floor ducts from the HVAC housing (1) and remove the ducts.
Floor Distribution Duct - Installation
INSTALLATION
1. Connect the rear floor ducts (2 and 5) to the HVAC housing (1).
2. Engage the rear floor ducts to the studs (4) and the floor support bracket (3).
3. Reposition the front carpet See: Body and Frame/Interior Moulding / Trim/Carpet/Service and Repair/Carpet - Installation.
4. Install the front seats See: Body and Frame/Seats/Service and Repair.
Instrument Panel Duct - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: Take the proper precautions to protect the instrument panel from cosmetic damage.
