RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
6. Remove the three screws (2 and 5) that secure the blower motor and evaporator housing (6) to the HVAC housing (3).
7. Carefully disengage the nine retaining tabs (1 and 4) that secure the blower motor and evaporator housing the HVAC housing.
8. Carefully separate the blower motor and evaporator housing from the HVAC housing
NOTE: If the foam insulator around the A/C evaporator is deformed or damaged, the insulator must be replaced.
9. If required, remove the A/C evaporator (1) from the blower motor and evaporator housing (2).
10. If the A/C evaporator is going to be reused, remove and discard the O-ring seals from the evaporator fittings and install plugs into, or tape over the
evaporator ports.
11. If equipped with dual zone system, disconnect the HVAC wire harness connector (2) and remove the two screws (4) that secure the blend door
actuator (3) to the front of the HVAC housing (1) and remove the actuator.