RAM 3500 Truck 2WD L6-6.7L DSL Turbo (2010)
Refrigerant Pressure Sensor / Switch: Description and Operation
A/C Pressure Transducer - Operation
OPERATION
The A/C pressure transducer monitors the pressures in the high side of the A/C refrigerant system through its connection to a fitting on the A/C discharge
line and its internal resistance changes in response to the pressures it monitors. The Powertrain Control Module (PCM) or Engine Control Module
(ECM), depending on engine application, provides a five volt reference signal and a sensor ground to the A/C pressure transducer, then monitors the
output voltage of the transducer on a sensor return circuit to determine refrigerant pressure. The PCM/ECM is programmed to respond to this and other
sensor inputs by controlling the operation of the A/C clutch and the radiator cooling fan to help optimize A/C system performance and to protect the
system components from damage. The PCM/ECM will disengage the A/C clutch when high side pressure rises above 3172 kPa (460 psi) and re-engage
the clutch when high side pressure drops below 1999 kPa (290 psi). The A/C pressure transducer will also disengage the A/C clutch if the high side
pressure drops below 193 kPa (28 psi) and will re-engage the clutch when the high side pressure rises above 234 kPa (34 psi). If the refrigerant pressure
rises above 1655 kPa (240 psi), the PCM/ECM will actuate the cooling fan. The A/C pressure transducer signal to the PCM/ECM also prevents the A/C
clutch from engaging when ambient temperatures are below about 10° C (50° F), due to the pressure/temperature relationship of the refrigerant.
A Schrader-type valve in the A/C discharge line fitting permits the A/C pressure transducer to be removed or installed without disturbing the refrigerant
in the A/C system.
The A/C pressure transducer is diagnosed using a scan tool See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures or (Refer to DTC-Based Diagnostics/MODULE, Engine Control (ECM) -
Diagnosis and Testing).
The A/C pressure transducer cannot be adjusted or repaired and must be replaced if inoperative or damaged.
