RAM 3500 Truck 2WD V10-8.0L VIN W MDC (1999)
Timing Cover: Service and Repair
REMOVAL
1. Disconnect the negative cable from the battery.
2. Drain cooling system (Refer to Cooling System,).
3. Remove the serpentine belt (Refer to Drive Belts, Mounts, Brackets and Accessories).
4. Remove fan shroud.
5. Remove fan.
6. Unbolt A/C compressor and set on top of engine.
7. Remove generator, air pump, and bracket assembly.
8. Remove water pump (Refer to Cooling System,).
Pulley-Damper Removal
9. Using a 3-prong puller to remove pulley/ damper from the crankshaft.
10. Loosen oil pan bolts and remove the front oil pan bolts that mount the pan to the timing chain cover.
11. Remove the cover bolts.
12. Remove timing chain cover and gasket using extreme caution to avoid damaging oil pan gasket.
13. Inspect surface of cover. Remove any burrs or high spots.
INSTALLATION
1. Be sure mating surfaces of timing chain cover and cylinder block are clean and free from burrs.
Priming Oil Pump
