RAM 3500 Truck 4WD L6-5.9L DSL Turbo VIN C (2002)
Rear Door Panel: Service and Repair
Trim Panel
TRIM PANEL
REMOVAL
Fig. 10
1. Remove the window crank, if equipped. (Fig. 10)
2. Remove the interior handle. Refer to Rear Door Interior Handle.
Fig. 9
3. Remove the screw near the inside handle. (Fig. 9)
CAUTION: Trim panel is attached to the door using hooks molded into the panel. Do not pull the trim panel straight off or damage to
the panel and/or power switch assembly may occur.
4. Lift the trim panel up off the belt seal and attachment hooks and separate the panel from the door slightly.
5. Disconnect the power window switch electrical connector, if equipped, and remove the trim panel.
INSTALLATION
1. Position the trim panel onto the lower hooks and connect the power window switch electrical connector, if equipped.