RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Ball Joint: Service and Repair
Front - Independent Front Suspension
Removal
REMOVAL
1. Raise vehicle and support the axle.
2. Remove the tire and wheel.
3. Remove the upper ball joint retaining nut.
4. Separate the upper ball joint (4) from the knuckle (6) using separator #9360 (5).
5. Remove the wheel speed sensor wire from the knuckle (HD) and from the upper control arm (LD).
6. Move the knuckle out of the way to allow ball joint removal tool access.
7. Remove the ball joint boot for removal.
NOTE: It may be necessary to install a block of wood between the control arm and frame bracket to allow clearance for the ball joint
press tool.
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and
insure proper operation during the removal and installation process.
8. Press the ball joint (4) from the upper control arm (3) using special tools C-4212-F (PRESS) (1), 9770-1 (Receiver) (2) and 9770-2 (Driver) (5).
Installation
INSTALLATION