RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
29. Remove the defroster-air doors (1) from the lower half of the HVAC housing (2) by carefully release the retaining tabs of actuator coupler (3)
located on the inside surface of the housing and pull the actuator coupler out of the pivot shaft of the defroster-air doors.
NOTE: If the seals on an air door is deformed or damaged, that air door must be replaced.
30. Remove the defroster-air doors from the HVAC housing.
NOTE: If the foam seal for the A/C evaporator tubes is deformed or damaged, the seal must be replaced.
31. Remove the foam seal (1) from around the tubes of the A/C evaporator (3).
32. Carefully lift the A/C evaporator out of the upper half of the HVAC housing (2).
Air Inlet Housing
AIR INLET HOUSING
NOTE: The air inlet housing does not need to be removed from the HVAC housing for service of the recirculation-air door See: Air
Door/Service and Repair/Recirculation Air Door - Removal .
1. Remove the air inlet housing (1) from the HVAC housing and place it on a workbench See: Removal and Replacement/HVAC Housing - Removal
2. Remove the baffle (2) from the air inlet housing.
