RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: Install valve body on a slight angle and verify that the shaft on the manual shift valve and the roller detent spring (11) has properly
engaged the manual valve lever (13).
NOTE: Bolts with conical washers are not reusable.
4. Install the valve body onto the transmission case.
5. Install and then tighten the bolts in the following order:
a. Install bolts (2*) and (3*) and tighten by hand in order to hold valve body onto transmission case.
b. Install detent spring , (10), (11) and bolts (5), (8) with wave washer (9), and tighten by hand.
c. Install clamp (12) along with bolt (15) on the prescribed position and tighten by hand.
d. Install bolts (15), (4), (6) and (7) on each correct position and tighten by hand.
e. Tighten bolts (2*) and (3*) to 10 Nm ( 88 in.lbs.).
f.
Tighten bolts (4), (5), (6),(7), (15) to 10 Nm ( 88 in.lbs.) and (8) to 5.5 Nm (49 in. lbs.).
VALVE BODY SOLENOID HARNESS
6. Install the white wire onto the oil pressure switch number seven (5).
7. Install the black wire onto the oil pressure switch number eight (6).
