RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Washer Fluid Level Switch: Service and Repair
Installation
DIESEL ENGINE
1. Install a new rubber grommet seal into the washer fluid level switch mounting hole in the washer reservoir (2). Always use a new rubber grommet
seal on the reservoir.
2. Insert the nipple formation of the switch (5) through the rubber grommet seal and in the reservoir.
3. Using hand pressure, press firmly and evenly on the switch mounting flange until the barbed nipple is fully seated in the rubber grommet seal in
the reservoir. The flat edge of the switch mounting flange should be pointed upward.
4. Reconnect the left headlamp and dash wire harness (1) connector for the switch to the switch connector receptacle.
5. Reconnect the removed washer hose (4) to the barbed outlet nipple of the washer pump/motor unit (3).
6. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.
7. Reconnect the battery negative cable.
