RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
1. Apply (EP) N.L.G.I. Grade 1 or 2 grease to inside of yoke bores.
2. Fit cross into the propeller shaft yoke.
3. Place bearing cap over the trunnion and align cap with the yoke bore. Keep needle bearings upright in the bearing cap.
4. Press bearing cap into yoke bore enough to clear snap ring groove and install snap-ring.
5. Flip propeller shaft yoke and install other bearing cap onto the opposite trunnion and install a snap ring.