RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
10. Remove pinion gear (1) from housing, with Pinion Driver 8977 (2) and a hammer.
NOTE: Thread the driver on the pinion shaft till it bottoms out.
11. Remove pinion seal with a slide hammer or pry bar.
12. Remove and discard front pinion bearing.
CAUTION: Do not reuse front pinion bearing/cup.
13. Remove collapsible spacer from the pinion shaft.
14. Remove rear pinion bearing with Puller C-293-PA (1) and Adapter Blocks 8879 (4).
15. Remove pinion depth shim from pinion gear shaft and record shim thickness.
16. Remove front pinion bearing cup from the housing with a punch and hammer and discard cup.
CAUTION: Do not reuse front pinion bearing/cup.
17. Remove rear pinion bearing cup from the housing with a punch and hammer, if bearing is going to be replaced.
Installation
INSTALLATION
