RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
TRS REMOVAL/INSTALLATION
4. Pry open the tabs on the stake washer (5), remove the nut (3) and the stake washer (5).
5. Remove the bolts (2).
6. Remove the transmission range sensor (1) from the transmission control shaft (4).
Installation
INSTALLATION
1. Install the transmission range sensor (3) onto the control shaft (5).
2. Install the stake washer and the nut (4) and hand tighten.
3. With the transmission in neutral install the alignment tool 9983 (6) onto the control shaft (5) and into the alignment hole (1).
4. Install the bolts (2).
5. After aligning the transmission range sensor, tighten the bolts (2) 12.5 Nm (9 ft.lbs.)