RAM SRT-10 Pickup V10-505 8.3L (2004)
CAUTION: Do not exceed 52 degrees C (120 degrees F) when heating the cladding or body panels. Failure to follow this caution may
result in damage to the cladding and/or the vehicle paint finish.
NOTE: If ambient temperatures are below 21 degrees C (70 degrees F), warm the body side cladding and body panel with a heat lamp or gun to
assure proper adhesion.
3. Remove the protective covering from the adhesive tape on the back of the body side cladding (2) and position the cladding onto the door panel
using the previously installed guide tape.
NOTE: To ensure proper cladding adhesion, apply consistent and uniform pressure of approximately 40 p.s.i. over the entire surface of the
cladding.
4. Install the body side cladding onto the door panel using the locating pin (1). Fully engage the push-pin retainers (3).
