Sprinter 2500 L5-2.7L DSL Turbo (2003)
Control Module HVAC: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Rear Roof Duct Panel
2. Remove the rear dome light from the rear roof duct panel.
3. Disconnect the dome light wire harness connector and remove the dome light from vehicle.
4. Remove the six push-pin roof duct panel fasteners and remove the duct panel from the vehicle.
5. Remove the five evaporator panel screws at the front of the panel.
Rear Evaporator Panel
6. If equipped, remove the interior motion sensor from the evaporator panel, disconnect the wire harness connector and remove the motion sensor
from the vehicle.
7. Remove the three push-in evaporator panel fasteners at the rear of the panel.
8. Remove the rear evaporator panel from the vehicle.
