Sprinter 2500 L5-2.7L DSL Turbo (2003)
Washer Reservoir Mounting
2. Engage the lower mounting post of the washer reservoir into the grommet in the top of the right front wheel house.
3. Engage the rear mounting post of the washer reservoir into the grommet in the dash panel.
4. Position the washer reservoir mounting hole over the stud nut on the right inner fender.
5. Install and tighten the nut and washer that secures the top of the washer reservoir to the stud nut on the right inner fender. Tighten the nut to 6 N.m
(50 in. lbs.).
6. Reconnect the washer supply hose to the barbed outlet nipple of the washer pump/motor.
7. Engage the washer supply hose into the routing trough integral to the top of the washer reservoir.
8. Reconnect the vehicle wire harness connector for the washer pump/motor unit to the motor connector receptacle.
9. Engage the vehicle wire harness into the routing clip integral to the front of the washer reservoir.
10. Reinstall the upper turbocharger heat shield and the upper air cleaner housing into the engine compartment.
11. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.
12. Reconnect the battery negative cable.
