Sprinter 2500 V6-3.0L DSL Turbo (2008)
1. Remove the rivets and remove the lower panel.
2. Remove the rivets and remove the upper panel.
Bulkhead Trim Panel - Installation
INSTALLATION
1. Install the upper panel and replace rivets.
2. Install the lower panel and replace rivets.
Cowl Trim - Removal
REMOVAL
1. Position door weatherstrip aside.
2. Remove the jack storage cover, if necessary.
3. Position aside carpet/mat, if necessary.
4. Using a trim stick C-4755 or equivalent, remove the cowl trim panel.
Cowl Trim - Installation
INSTALLATION
1. Position the cowl trim panel and seat the clips fully.
2. Install the jack storage cover, if necessary.
3. Position the carpet/mat back.
4. Position the door weatherstrips back.
Front Door Trim Panel - Removal
REMOVAL
1. Release the cover (7).
2. Remove the door pocket (13).
3. Remove the bolts (6, 8, 10).
4. Using a trim stick C-4755 or equivalent, release the door trim retainers and pull the trim panel (2) upward over the lock button.
5. Unhook the inside door opener cable (1).
6. Disconnect the electrical connector (4) from the control panel (5).
7. Remove the trim panel (2).
Front Door Trim Panel - Installation