Sprinter 3500 L5-2.7L DSL Turbo (2004)
Air Bag: Service and Repair
Passenger Airbag Bracket
REMOVAL
WARNING: TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE
SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG, SEAT
BELT TENSIONER, IMPACT SENSOR, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND
ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL
AIRBAG DEPLOYMENT.
1. Remove the passenger airbag from the instrument panel.
Passenger Airbag Bracket Remove/Install
2. Remove the four screws that secure the passenger airbag bracket to the instrument panel structural support.
3. Remove the passenger airbag bracket from the instrument panel structural support.
INSTALLATION
1. Position the passenger airbag bracket onto the instrument panel structural support.
2. Install and tighten the four screws that secure the passenger airbag bracket to the instrument panel structural support. Tighten the screws to 10 Nm
(89 in. lbs.).
3. Reinstall the passenger airbag into the instrument panel.
