SRT-4 L4-2.4L Turbo VIN S (2004)
6. Install the bolt that secures the suction and liquid line fitting to the A/C expansion valve. Tighten the bolt to 20 Nm (15 ft. lbs.).
7. Position the front suction line into the engine compartment.
8. Remove the tape or plugs from the front suction line fitting and the mid-line connector block.
9. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the suction line fitting. Use only the specified O-rings as they are
made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the compressor in the vehicle.
10. Connect the front suction line fitting to the mid-line connector block.
11. Install the nut that secures the front suction line fitting to the mid-line connector block. Tighten the nut to 4.5 Nm (40 in. lbs.).
12. Remove the tape or plugs from the opened liquid line fitting and receiver/drier outlet port.
13. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the liquid line fitting. Use only the specified O-rings as they are made
of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the compressor in the vehicle.
14. Reconnect the liquid line fitting to the receiver/drier outlet port.
15. Install the bolt that secures the liquid line fitting to the receiver/drier. Tighten the bolt to 2.3 Nm (20 in. lbs.).
16. If equipped, reinstall the vehicle speed control servo.
17. Remove the tape or plugs from the A/C compressor suction port and the suction line fitting.
18. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the suction line fitting. Use only the specified O-rings as they are
made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
19. Connect the suction line fitting to the A/C compressor suction port.
20. Install the bolt that secures the suction line fitting to the A/C compressor. Tighten the bolt to 12 Nm (108 in. lbs.).
21. Install the suction line retaining brackets as required.
22. Evacuate the refrigerant system.
23. Recharge the refrigerant system.
