SRT-4 L4-2.4L Turbo VIN S (2004)
Power Steering Fluid Cooler: Service and Repair
Installation
INSTALLATION - FLUID COOLER
1. Position power steering fluid cooler on crossmember and install fasteners. Tighten fasteners to 10 Nm (90 inch lbs.) torque.
2. Using a lint free towel, wipe clean open power steering hose end, cooler hose and tube ends, and gear tube/fitting.
3. Position hose clamp onto end of cooler hose (at gear outlet tube/fitting) far enough to clear outlet tube once installed.
4. Slide cooler hose onto power steering gear return outlet tube/fitting (Fig. 21). Slide hose clamp on hose past bead formed into end of tube and
secure in place.
5. Position hose clamp onto end of return hose (at cooler) far enough to clear outlet tube once installed.
6. Slide return hose onto power steering cooler outlet tube (Fig. 21). Slide hose clamp on hose past bead formed into end of tube and secure in place.
7. Lower vehicle.
8. Perform POWER STEERING PUMP INITIAL OPERATION procedure to properly fill and bleed power steering system.
9. Check for leaks.
