SRT-4 L4-2.4L Turbo VIN S (2004)
4. Route the hydraulic tube as noted upon removal.
5. Raise vehicle on hoist.
6. If master cylinder is being replaced, install service replacement slave cylinder. If master cylinder is being re-used, install slave cylinder as shown
in (Fig. 41).
7. If master cylinder is being replaced, connect the master cylinder hydraulic line to the service replacement slave cylinder hydraulic line. An audible
click should be heard. Verify the connection by pulling outward on the master cylinder line.
8. Lower vehicle.
9. Install the master cylinder remote reservoir onto the dash panel.
10. Install the reservoir retaining screws. Tighten the screws to 3 Nm (24 inch lbs.).
11. Install the clutch interlock/upstop switch and cover plate. (Fig. 45)
CAUTION: Inspect the clutch master cylinder push rod plastic retainer for damage. If it is damaged (broken/cracked), it MUST be replaced.
12. Install the push rod onto the pedal pin.
13. Depress and release the clutch pedal a minimum of ten (10) times to allow any residual air in the system to be vented to the reservoir. If residual
air becomes trapped in the system, bleed the clutch hydraulic system.
14. Connect the negative battery cable.
15. Top off clutch master cylinder reservoir with DOT 3 brake fluid.
16. Verify proper clutch operation.
