Stratus Coupe V6-3.0L VIN H (2001)
3.
Lower the glass and check that the glass is positioned in the center of the sash (parallel to glass travel). If necessary make adjustments to center the
sash to the glass (Fig. 3).
4.
If no other symptom/conditions exist, re-install the door panel.
Symptom/Condition 3 - Inner Belt Line Molding (Built Prior To 1/26/01).
1.
The inner belt line molding was re-designed (Fig. 4) to reduce pressure on the glass.
2.
Replace the inner belt line molding Left p/n MR271759 or Right p/n MR271760 if necessary as follows:
a.
Remove the door trim panel.
