Stratus Coupe V6-3.0L VIN H (2001)
STEP 2. Check the multi-center display connector C-08 for damage.
Q: Is the multi-center display connector C-08 in good condition?
YES: Go to Step 3.
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 3. Check the harness wires between multi-center display connector C-08 and ground.
NOTE: After checking joint connector C-141, check the wires. If joint connector C-141 is damaged, repair or replace it. Refer to Harness Connector
Inspection.
Q: Is the harness wires between multi-center display connector C-08 and ground in good condition?
YES: There is no action to be taken.
NO: Repair them. The multi-center display should work normally.
STEP 4. Check the multi-center display power supply circuit (battery) at the multi-center display connector C-08 by backprobing.
1. Do not disconnect the multi-center display connector C-08 and measure at the harness side.
2. Measure the voltage between terminal 1 and ground by backprobing.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 7.
NO: Go to Step 5.
