dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Component Tests and General Diagnostics|Page 1888 > < Component Tests and General Diagnostics|Page 1886
Page 41
background image

1. Disconnect the ETACS-ECU connector C-311 and measure at the junction block side.

2. Measure the voltage between terminal 16 and ground.

Q: Is the voltage approximately 12 volts (battery positive voltage)?

YES: Go to Step 4.
NO: Go to Step 2.

STEP 2. Check the junction block connector C-311 for damage.

Q: Is junction block connector C-311 in good condition?

YES: Go to Step 3.
NO: Repair or replace it. Refer to Harness Connector Inspection. The central door locking system should work normally.

Component Tests and General Diagnostics|Page 1888 > < Component Tests and General Diagnostics|Page 1886