Stratus Coupe V6-3.0L VIN H (2001)
1. Use special tool MB991529 to connect a voltmeter between ground terminal 4 or 5 and ETACS-ECU terminal 9 of the data link connector.
2. Check that the voltmeter indicator deflects once when the input signal enters.
Q: Does the voltmeter indicator deflect?
YES: Go to Step 4.
NO: Check the windshield wiper switch input circuit. Refer to Inspection Procedure O-16.
STEP 4. Check the windshield wiper motor.
1. Disconnect the wiper motor connector A-03.
2. Connect a battery to the wiper motor as shown in the illustration and check motor operation at low-speed and high-speed.
Q: Is the wiper motor in good condition?
YES: Go to Step 5.
NO: Replace the wiper motor. The windshield wiper should work normally when the windshield wiper switch is set to all positions.