Stratus Coupe V6-3.0L VIN H (2001)
2. Connect terminal 53 to the ground.
Q: Does the high-beam indicator light illuminate?
YES: Go to Step 10.
NO: Go to Step 3.
STEP 3. Check the high-beam indicator light bulb.
Q: Is the high-beam indicator light bulb in good condition?
YES: Go to Step 4.
NO: Replace it. The high-beam indicator light should work normally.
STEP 4. Check the combination meter (printed-circuit board).
1. Remove the combination meter.
2. Remove the high-beam indicator light bulb. Then measure the resistance between the bulb terminals.
3. Install the bulb to the combination meter, and then measure the resistance between connector C-102 terminal 21 and 22. The resistance reading at
this time should be much the same as the resistance measured at Step (2).
Q: Are the two resistance values extremely different each other?
YES: Repair or replace the combination meter (printed circuit board). The high-beam indicator light should work normally.
NO (much the same): Go to Step 5.
STEP 5. Check the combination meter power supply circuit at the combination meter connector C-102.
1. Disconnect the combination meter connector C-102 and measure at the harness side.
