Stratus Coupe V6-3.0L VIN H (2001)
STEP 8. Check combination meter connector C-102 and ETACS-ECU connector C-313 for damage.
Q: Are combination meter connector C-102 and ETACS-ECU connector C-313 in good condition?
YES: Go to Step 9.
NO: Repair or replace them. Refer to Harness Connector Inspection. The high-beam indicator light should work normally.
STEP 9. Check the harness wire between combination meter connector C-102 and ETACS-ECU connector C-313.
Q: Is the harness wire between combination meter connector C-102 and ETACS-ECU connector C-313 in good condition?
YES: There is no action to be taken.
NO: Repair it. The high-beam indicator light should work normally.
STEP 10. Replacement of ECU.
1. Replace the ETACS-ECU.
2. The high-beam indicator light should work normally.
Q: Is the high-beam Indicator light working normally?
YES: There is no action to be taken.
NO: Replace the front-ECU. The high-beam indicator light should work normally.
Inspection Procedure K-1
Flasher timer: Turn-signal lights does not flash when the turn-signal light switch is turned on.
