Stratus Coupe V6-3.0L VIN H (2001)
STEP 3. Check the harness wires between ETACS-ECU connector C-311 and ignition switch (ACC).
NOTE: After checking junction block connector C-301, check the wires. If junction block connector C-301 is damaged, repair or replace it. Refer to
Harness Connector Inspection.
Q: Are the harness wires between ETACS-ECU connector C-311 and ignition switch (ACC) in good condition?
YES: There is no action to be taken.
NO: Repair them. The ignition switch (ACC) input signal should be able to be checked and the windshield wiper and washer should work normally.
Inspection Procedure O-2
The ignition switch (IG1) signal is not sent to the ETACS-ECU.
