dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Recall - Fuel Return Hose Replacement|Page 2543 > < Recall - Fuel Return Hose Replacement|Page 2541
Page 4
background image

6.

Disconnect the fuel return hose from the fuel pump module (Figure 4).

7.

Raise the vehicle on the hoist.

8.

Using a transmission jack, support the fuel tank.

9.

Remove the two (2) FRONT fuel tank strap nuts.

10.

Lower the front of the fuel tank about 3 inches.

11.

Disconnect the fuel return hose from the return tube (Figure 5).

12.

Remove the return hose from the two (2) clips on the top of the fuel tank and then discard the hose.

IMPORTANT:

Remember to save the small hose clamps for use with the new hose.

13.

Install the new fuel hose along the top of the fuel tank and secure it in the two (2) clips.

14.

Connect the return hose to the return tube. Make sure that the hose clamp is properly installed.

15.

Raise the fuel tank into position.

16.

Install the fuel tank straps. Tighten the strap nuts to 19 ft-lbs (26 Nm).

17.

Remove the transmission jack.

18.

Lower the vehicle.

19.

Connect the new return hose to the fuel pump module (Figure 4). Make sure that the hose clamp is properly installed.

Recall - Fuel Return Hose Replacement|Page 2543 > < Recall - Fuel Return Hose Replacement|Page 2541