Stratus Sedan V6-2.7L (2001)
Sunroof / Moonroof Panel: Procedures
Sunroof Glass Panel
GLASS PANEL
REMOVAL
1. Slide sunshade rearward to the open position.
2. Move the glass panel to the vent position.
Fig.3 Sunroof Glass Panel Screws
3. Remove the glass panel screws on each side.
4. Lift off glass panel and remove from vehicle.
INSTALLATION
1. Position glass panel on to mechanism.
2. Start the six attaching screws.
3. Close glass.
4. Center glass in opening by running a business card around the glass.
5. Adjust front height of glass, just below roof panel.
6. Tighten front two screws.
7. Adjust rear height of glass, just above roof panel.
8. Tighten remaining screws.
9. Verify sunroof operation and alignment. Check fit and adjust as necessary.
Sunroof Glass Panel Seal
REMOVAL
1. Remove sunroof glass panel.
2. Grasp the seal and pull seal away from the glass panel. The seal is a one piece seal.
INSTALLATION
NOTE: Always position seal seam on center of the passenger side of glass panel.
1. Install seal on glass. Using care working the seal around the glass, being careful not to over stretch the seal while installing.
2. Install sunroof glass panel.
3. Test sunroof operation, adjust as necessary.
