dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine - Idle Roughness|Page 2868 > < Input Speed Sensor|Page 2859
Page 1
background image

PROM - Programmable Read Only Memory: Customer Interest
Engine - Idle Roughness

NUMBER: 18-028-01

GROUP: Vehicle Performance

DATE: Nov. 23, 2001

THIS BULLETIN IS BEING PROVIDED IN ADVANCE. DO NOT PERFORM ANY ACTIONS RELATED TO THIS BULLETIN UNTIL
DECEMBER 10, 2001. THE MDS2 MUST BE OPERATING WITH CIS CD2097 OR HIGHER.

SUBJECT:
Engine Idle Roughness

OVERVIEW:

This bulletin involves reprogramming the Powertrain Control Module (PCM) with new software.

MODELS:

2001

(JR)

Sebring Convertible/Sebring Sedan/Stratus

NOTE:

THIS INFORMATION APPLIES TO VEHICLES EQUIPPED WITH A 2.7L ENGINE (SALES CODE EES).

SYMPTOM/CONDITION:

^

Rough idle following a cold start. More prevalent in ambient temperatures of 10°C. to 21°C. (50°F. to 70°F.).

^

Engine speed flares or rough idle while slowing to a stop. May be attributed to an accessory load (power steering, A/C, or generator).

DIAGNOSIS:

If Diagnostic Trouble Codes (DTC's) are present, record them on the repair order and repair as necessary before proceeding further with this bulletin. If
the condition(s) can be duplicated or are described by the customer, perform the Repair Procedure.

PARTS REQUIRED:

EQUIPMENT REQUIRED:

REPAIR PROCEDURE:

1.

Flash the PCM using the MDS2 (Mopar Diagnostic System) and DRB III(R) (Scan Tool).

NOTE:

THE FOLLOWING STEPS ARE REQUIRED BY LAW.

Engine - Idle Roughness|Page 2868 > < Input Speed Sensor|Page 2859