Viper SRT-10 V10-8.4L (2008)
8. Install shock assembly (6) into mounting bracket on lower control arm (5). Install shock assembly mounting bolt and nut. DO NOT TIGHTEN
MOUNTING BOLT AT THIS TIME.
9. Install stabilizer bar link (4) into mounting hole on lower control arm (5). Install stabilizer bar link nut and tighten to 23 Nm (17 ft. lbs.).
10. Install ABS wheel speed sensor head (2) in steering knuckle (1). Install and tighten mounting bolt (3) to 11 Nm (100 in. lbs.).
11. Install brake rotor and brake caliper on knuckle. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and
Repair/Removal and Replacement/Brake Rotor - Installation
12. Install wheel and tire assembly See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation.
Progressively tighten wheel mounting nuts in proper sequence to 135 Nm (100 ft. lbs.).
13. Lower vehicle.
14. Position vehicle on alignment rack/drive-on hoist.
15. Set vehicle to design height. See: Alignment/Service and Repair.
16. Tighten shock assembly lower mounting bolt to 135 Nm (100 ft. lbs.).
17. Return vehicle to curb height.
