Medallion L4-2165cc 2.2L (1988)
Control Arm Bushing: Service and Repair
Fig. 12 Using driver/receiver for bushing removal
REMOVAL
1. Using a suitable press, drive bushings (A) out.
2. Use suitable size sockets of sections of pipe as a bushing driver (B) and a bushing receiver (C).
3. The driver (B) outside diameter should be 1.34 inches.
4. The receiver (C) inside diameter should be 1.42 inches.
Fig. 13 Obtaining dimension E
INSTALLATION
Install replacement bushings using a suitable press and the same bushing driver/receiver tools used during removal. The control arm bushing are not
identical and should not be interchanged from one side to the next. Press the bushings (D), into the control arm equally and in small increments.
Dimension (E) must be 7.48 inches plus or minus 0.019 inch. Dimension (F) must be the same at both bushing locations.
