Vision V6-3.5L VIN F (1997)
Removing Or Installing Braking Disc
2.
If removed, install rotor on hub.
Removing Caliper Assembly
3.
Carefully position caliper and brake shoe assemblies over rotor using the reversed required removal procedure.
CAUTION: When being installed, extreme caution should be taken not to crossthread the caliper guide pin bolts.
4.
Install the caliper guide pin bolts. Tighten guide pin bolts to a torque of 22 Nm (192 in. lbs.).
5.
Install the wheel and tire assembly.
6.
Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to
the full specified torque of 110 - 135 Nm (85 - 115 ft. lbs.).
7.
Remove jackstands or lower hoist. Before moving vehicle, pump the brake pedal several times to insure the vehicle has a firm brake pedal to
adequately stop vehicle.
WARNING: Before moving vehicle after performing any service to the vehicle brake system, be sure to obtain a firm brake pedal.
8.
Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoe linings.
Removal
