Vision V6-3.5L VIN F (1997)
Park Brake Cable Removal From Floor Pan
13.
Remove rear park brake cable from vehicle floor pan using the following procedure. Disconnect rear park brake cable requiring replacement
from equalizer. Slip the box end of a 1/2 inch over end of park brake cable. This will compress retaining tabs on end of park brake cable
housing. Using a screw driver, press on end of park brake cable housing to remove cable from floor pan of vehicle.
Installation
PROCEDURE
1.
Raise vehicle.
Park Brake Cable Attachment To Park Brake Lever
2.
Install parking brake cable into rear brake support plate. Be sure the park brake retainers are expanded around mounting hole in brake support
plate. Connect parking brake cable to park brake lever on trailing brake shoe.
3.
Install parking brake cable into cable mounting hole in floor pan of vehicle. Be sure that cable retainers are expanded around mounting hole in
floor pan.
