Aerostar 2WD V6-182 3.0L (1995)
Caliper Slide Pin Positioning
7. From the caliper outboard side, position the pin between the front disc brake caliper and spindle grooves. The pin must be positioned so the tabs
will be installed against the spindle outer face.
NOTE: During the installation procedure, do not allow the tabs of the caliper pin to be tapped too far into the spindle groove. If this happens, it
will be necessary to tap the other end of the caliper pin until the tabs snap into place. The tabs on each end of the caliper pin must be free to catch
on the spindle face.
Caliper Pin Installation
8. Tap the pin on the outboard end with a hammer. Continue tapping the pin inward until the retention tabs on the sides of the pin contact the front
wheel spindle face. Repeat procedure for the lower pin.
9. If removed, install the front brake hose to the front disc brake caliper.
10. If the front brake hose was removed, perform brake bleeding procedures.
11. Install the wheel and tire assembly. Tighten lugnuts to 114-141 Nm (85-105 ft lb).
12. Lower vehicle, check the brake fluid level and fill as necessary. Check brakes for proper operation then recheck brake fluid level in brake master
cylinder. Fill as necessary.
