Removal and Installation | -
Disconnect the battery ground cable. For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | | -
Remove the air cleaner outlet pipe. | 3. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Fuel charging wiring harness electrical connector 3 - Engine coolant temperature (ECT) sensor electrical connector 7 - Variable camshaft timing (VCT) oil control solenoid electrical connectors 10 - Fuel charging wiring harness 4. To install, reverse the removal procedure. | -
Initialize the door window motors. For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures). | Removal Details Item 2 : Throttle body electrical connector | -
Disconnect the throttle body electrical connector. - Release the locking tangs.
| Item 5 : Oil pressure switch electrical connector | -
Raise and support the vehicle. For additional information, refer to: Lifting (100-02, Description and Operation). | | -
Disconnect the oil pressure switch electrical connector. - Release the locking tangs.
| Item 6 : Engine wiring harness retaining clip | -
Detach the engine loom wiring harness retaining clip from the fuel charging wiring harness. | Item 9 : Fuel charging wiring harness retaining clips | -
Detach the fuel charging wiring harness retaining clips from the valve cover. | Installation Details Item 5 : Oil pressure switch electrical connector | -
Raise and support the vehicle. For additional information, refer to: Lifting (100-02, Description and Operation). | | -
Connect the oil pressure switch electrical connector. | Item 4 : Positive crankcase ventilation (PCV) breather hose NOTE:Make sure that the PCV breather hose is clean and free from any oil residue as this will reduce the installation grip of the PCV breather hose. |