Contour V6-153 2.5L DOHC (1996)
5.
Install the fan blades. Spin each blade to make sure the motors are properly centered so that the blades do not contact the shroud. If contact occurs,
loosen the motor attaching screws and adjust the motor(s) as needed. See Figure 16.
6.
Install the new retaining clips and plates, included in kit, onto the fan motor shafts. See Figure 16.
7.
Connect the fan motors.
8.
Proceed to Cooling Fan Assembly -- Installation
2.0L Engine - Install - Supplement
1.
While an assistant positions the A/C accumulator and lines toward the transaxle, install the cooling fan assembly into the vehicle. See Figure 11.
2.
Raise and support the vehicle.
3.
Install the A/C accumulator mounting bracket bolts to the subframe, if equipped. Tighten the bolts to 11 Nm (8 lb-ft).
4.
On vehicles equipped with an automatic transaxle, install the transaxle cooling line routing clip onto the fan shroud.
5.
Install the lower air deflector.
6.
Lower the vehicle.
7.
Secure the engine cooling fan assembly to the radiator. Tighten the retainers to 4 Nm (35 lb-in).
8.
Secure the oxygen sensor wiring to the fan shroud.
9.
Connect the air conditioning compressor clutch cycling switch, if equipped.
10.
Connect then attach the power distribution harness connectors to the fan shroud.
11.
Install the ground wire to the radiator support.
12.
Connect the air conditioning compressor clutch connector, if equipped.
