Contour V6-153 2.5L DOHC (1996)
16.
Route accelerator cable under vacuum lines, shift cable, EGR connector and between A/C line and brake booster. See Figure 15.
17.
From inside vehicle, connect accelerator cable to accelerator pedal. Make sure cable bulkhead grommet is fully seated.
18.
Attach retainer W700637-S300 to top stud of Idle Air Control (IAC) valve. Secure accelerator cable in the retainer at point marked by the tape.
Refer to Figure 15. Accelerator cable should be close to, but not touching, brake booster.
19.
Connect accelerator cable to traction control motor.
