Crown Victoria V8-4.6L Flex Fuel (2008)
Fuel Gauge Sender: Service and Repair
FUEL PUMP MODULE
Removal and Installation
1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire
Suppression System. Failure to follow the instructions may result in serious personal injury.
Remove the fuel tank.
2. Disconnect the fuel pump (FP) module harness-to-fuel tank pressure (FTP) sensor electrical connector
3. Release the 2 FP module wiring harness retainers.
4. Clean the FP module mounting flange and immediate surrounding area of any dirt or foreign material.
5. CAUTION: The fuel pump (FP) module must be handled carefully to avoid damage to the float arm and the filter.
Remove the 6 bolts and the FP module.
-
To install, tighten to 10 Nm (89 lb-in).
6. Remove and discard the FP module seal.
