Crown Victoria V8-4.6L VIN W (2000)
7. Remove and discard the rear suspension lower arm pivot bolt and nut from the axle bracket.
8. Remove and discard the rear suspension lower arm pivot bolt and nut from the frame bracket. Remove the rear suspension lower arm.
Installation
All Vehicles
1. Note: The rear suspension lower arm bolts must be tightened with the vehicle at curb height.
Note: The rear suspension lower arms are interchangeable from side-to-side with "OUTBOARD" stamped on the side of the arm for positioning
during installation.
Position the rear suspension lower arm to the frame bracket and install a new pivot bolt and nut. Insert the bolt so the nut faces inboard. Do not
tighten at this time.
