Crown Victoria V8-4.6L VIN W (2000)
6. CAUTION: Do not use excessive force when removing the pivot bolt and flag nut on the right upper suspension arm to axle bracket. Damage to
the brake line can occur.
Remove and discard the rear suspension upper arm pivot bolt and nut from the axle bracket.
7. Remove and discard the rear suspension upper arm pivot bolt and nut from the frame bracket. Remove the rear suspension upper arm.
Installation
All Vehicles
1. Note: The rear suspension upper arm bolts must be tightened with the vehicle at curb height.
Note: The rear suspension upper arms are interchangeable from side-to-side with "FRONT" and "OUTBOARD" stamped on the side of the arms
for positioning during installation.
Position the rear suspension upper arm to the frame bracket and install a new pivot bolt and nut. Insert the bolt so the nut faces inboard. Do not
tighten at this time.
