Crown Victoria V8-4.6L VIN W (2000)
6. Disconnect the height sensor from the mounting bracket.
All Vehicles
7. Remove and discard both lateral arm assembly pivot bolts and nuts.
8. Note: The Watts link pivot stud is coated with a dry adhesive and must be replaced whenever the pivot nut or stud is loosened or removed with a
new Watts link pivot nut and stud service kit.
Note: If the Watts link pivot stud on the axle assembly loosens while removing the pivot nut, continue to loosen the pivot stud until you can insert
an open end wrench to hold the pivot stud. While holding the pivot stud, remove the pivot nut.
Remove and discard the Watts link pivot nut.
9. Lower the axle until the Watts link is free of the pivot stud. Remove the lateral arm assembly.
