Crown Victoria V8-4.6L VIN W (2000)
6. Twist the solenoid valve and remove.
Installation
1. Note: Be sure the new air spring solenoid is fully seated into both stages of the air spring.
Note: Check the solenoid valve O-rings for abrasion or cuts. Replace O-rings as required using air spring connector repair kit.
Note: Lightly apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification
ESE-M1C171-A to the O-rings.
Note: When installing the air lines, make sure the white air line is fully inserted into the fitting for correct installation.
To install, reverse removal procedure.
^
After installing the solenoid, it is necessary to inflate the air suspension system.