Crown Victoria V8-4.6L VIN W (2000)
Suspension Spring ( Coil / Leaf ): Service and Repair
Rear
Removal
CAUTION: Suspension fasteners are critical parts because they affect the performance of vital components and their failure can result in major
service expense. They must be replaced with the same part number or an equivalent part if replacement is necessary. Do not use a replacement part of
lesser quality or substitute design. Torque values must be used as specified during reassembly to ensure proper retention of these parts.
1. Mark the rear shock absorber relative to the protective sleeve with the vehicle in a static, level ground position (curb height).
2. Raise the vehicle on a hoist.
3. Remove both wheel and tire assemblies.
4. Disconnect the stabilizer bar from the stabilizer bar links.
1
Remove the nuts and the bushings.
2
Rotate the stabilizer bar off the links.
5. Use the special tool 014-00942 or equivalent to support the rear axle.
6. Remove the nuts and bolts and disconnect the lateral arms from the frame. Discard the nuts and bolts.
