E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
10. Carefully remove the windshield glass from the vehicle.
CAUTION: Removing the glass requires more than one technician.
11. Remove the windshield header seal.
12. Trim the remaining urethane on the pinch weld to within the specification.
^
The old urethane should be smooth and free of cuts and contamination.
INSTALLATION
1. Check the pinch weld for damaged sheet metal, raised sheet metal at the spot welds, rust or foreign material that could cause glass damage.
2. Apply Urethane Body Primer WSB-M2G234-C to any exposed metal on the pinch weld.
3. If re-installing the same windshield glass, removal all remaining traces of urethane sealant.
4. Clean the inside of the windshield glass with an alcohol free cleaner.
5. Apply Glass Primer WSB-M5B280-C2 (red) to the entire inside perimeter of the windshield glass. Wipe off immediately.
NOTE: Apply with deliberate strokes, making sure not to overlap the applied area.
6. Apply Glass Primer WSB-M2G314-B (black) to the entire inside perimeter of the windshield glass. Allow a minimum of 5 minutes dry time.
7. Install the windshield header seal on the windshield glass.
8. Apply an 11 mm (0.43 inch) bead of Urethane Sealant to the entire primed area of the windshield glass.
NOTE: The windshield glass must be positioned within 10 minutes of applying the urethane sealant.
