E 250 V10-6.8L VIN S (2005)
Lower and support the front of the vehicle.
7. NOTE: Reset the steering gear meshload only if the measured rotating torque for total on-center load is less than specification.
Attach a lb/in torque wrench to the bolt and measure the steering gear meshload from center.
8. Adjust if not within specification.
9. Adjust the sector shaft to proper rotating torque.
1. Hold the sector shaft and loosen the lock nut.
2. Adjust the sector shaft.
10. Verify that the rotating torque is to specification.
^
Reset if necessary.
