E 250 V8-4.6L VIN W (2006)
Tighten the bolts in the sequence shown.
^
Tighten to 10 Nm (89 inch lbs.).
4. Position the camshaft sprocket and install the bolt in 2 stages.
Stage 1: Tighten to 40 Nm (30 ft. lbs.).
Stage 2: Tighten an additional 90 degrees.
Windsor engine (5.4L)
5. Install the camshaft and the camshaft bearing caps in their original locations.
^
Lubricate the camshaft bearing caps with clean engine oil.
^
Position the camshaft bearing caps.
^
Install the bolts loosely.
6. Tighten the bolts in the sequence shown.
All engines
7. Install the timing chains.
8. Install the camshaft roller followers.