E 250 V8-4.6L VIN W (2006)
Disconnect the compressor manifold and tube assembly suction fitting.
-
Discard the O-ring seal.
-
To install, tighten to 47 Nm (35 lb-ft).
7. CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.
Disconnect condenser inlet fitting.
-
Discard the O-ring seal.
-
To install, tighten to 39 Nm (29 lb-ft).
8. Remove the compressor manifold and tube assembly.
9. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
10. Evacuate, leak test, and charge the refrigerant system.
